Technical FAQs

Ask a Question

PM1200 how to clear or reset INTG (where the energy parameters are accumulated)

INTG Clear

From RMS, press ^. The display will show CLR
2. CODE entry is required to clear the INTG values.
3. Press >  for 2 Seconds. The display will show CODE 2000 with blinking 2.
4. The factory set CODE is 1000. Press v. The display will show CODE
1000 with blinking 1.
5. Press key enter once or > key four times to accept the new value.
6. After the successful CODE entry, the display shows CLR INTG.
7. In order to clear INTG press > key. The display shows CLR INTG y
with blinking y. Go to step 9 to not clear the INTG.
8. Press > key to clear INTG. The display flashes PASS and then CLR
INTG. Go to step 11.
9. Press v key. The display will show CLR INTG n with blinking n.
10. Press >  key. The display flashes FAIL and then CLR INTG.
11. Press < key. The display shows CLR means exit.
12. Press v key to return to RMS page.
Was this helpful?
What can we do to improve the information ?