คำถามทางเทคนิคที่พบบ่อย

ตั้งคำถาม

How to replace external battery for TWIDO

Battery Installation Requirements
When installing or replacing the external battery, make sure the following two conditions are both met: 1. The internal battery of your Twido compact base must be fully charged. 2. After installing the external battery, you must power up your Twido controller immediately.

Note: Failure to meet any of the above two conditions will result in a significantly shorter battery life. The external battery life can be rapidly reduced to less than one month.

To install or replace an external battery, follow these steps: 

Step 1 ​Before installing or replacing the external battery, you must first make sure that the internal battery of your Twido controller is fully charged. This precaution is to ensure that the data stored in RAM memory are not lost when the external battery is removed from its compartment.

Step 2 Press sideways on the small latch protruding from the compartment cover to unlock the door of the battery compartment.

Step 3  Pull to open the compartment door, as shown in the figure below:



Step 4 Remove the used battery from the compartment, if any.

Step 5  Insert the new battery in the compartment, observing the correct polarity, as indicated by the polarity marking located inside the battery compartment.

Step 6  Close the door of the battery compartment (make sure the latch clicks into place to lock the compartment door).

Step 7  Power up your Twido controller immediately to preserve battery life.

***Please refer part reference for external battery is TSXPLP01 For compact base controllers TWD LCxx 40DRF
ข้อมูลนี้เป็นประโยชน์หรือไม่?
ข้อมูลใดที่เราควรทำการปรับปรุง?